28-6-2011 16 033000=13069F
3. Tamper contact.
4. Battery compartment.
5. Sensitivity switch 1/2 - In setting 1 the sensor will instantly
react to movement, in setting 2 the sensor is less sensitive
and will only react after registering multiple movements.
6. TEST button.
4.2.1 Mounting the Motion Detector MS18
The motion detector works by detecting changes in
temperature. Do not mount the detector too close to a
heater or air conditioner.
The motion detector has a range of 12m and an angle of
90°. Because of the special lens the sensor ‘looks down’.
Always mount the MS18 at a height of about 180 cm from
the floor and place it in such a way that the detector can
cover the area you want to secure. The mounting bracket
can be placed at an angle (90°) or directly against the wall.
4.2.2 Using the Motion Detector
1. Open the battery compartment and insert the batteries (2xAA, alkaline).
2. Keep the TEST button (6) pressed for about 4 seconds. The LED will flash once. Release the
button. The LED will flash twice. The motion detector has now chosen a unique code, which
can be registered with your console. Place the motion detector upside down so that it can’t
detect any movement during registration.
Test mode: Testing the location of your motion detector
1. Set the switch (5) to 1.
2. Press the TEST button (6) until the indicator (1) flashes twice.
3. Wait 20-30 seconds.
4. Walk in front of the sensor. The indicator (1) lets you know when a movement has been
detected. This allows you to check whether the sensor has been mounted on the right place.
5. Press the TEST button again to be able to use the sensor as normal.
After 2 minutes the motion detector will go back to the normal mode.
4.2.3 Registering a Motion Detector with the Console
1. To access the menu, press the menu UP or menu DOWN button. The display now shows
ENTER PIN.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The
display is cleared and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word INSTALL will show up on the
display.
4. Press OK. The display will read INSTALL ZONE.
5. Press the TEST button of the motion detector or turn it around, so that the sensor will detect
movement. The console will beep to confirm. The display will read ZONE …’. SET.
A memory space for a sensor is called a zone. If you have more than 1 sensor installed, it will
show e.g. ZONE 2 SET, ZONE 3 SET, … ZONE 30 SET.
You can choose in which zone you want to install the sensor. If you want to install the sensor in
zone 3, press 3 on the number pad before executing step 5.
It’s advisable to write down which zone contains which sensor. There’s space reserved at the
back of this user manual.
6. Repeat step 5 for every motion detector you wish to register.
7. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2 for No. If you
choose Yes, you will quit the menu. If you choose No, you go back to the first menu item. .
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji